Vibration Measuring

The building earthquake monitoring solution

Update time：2012-03-14 08:46　　　 Viewed：次

【SW - 011 - SYS】 record the effect of isolation system

Product introduction:

In Japan, this system is usually installed in the isolation layer of isolation building (the part at the top of vibration isolator) and the non-vibration isolation layer (on the ground) ,

Evaluate the isolation effect of the vibration’s structure through real-time waveform . It is also known as Health Monitoring.

Plan One

Number of seismograph installed:

①on the ground ② above the vibration isolation system (1 For B1F)③ middle layer (also can be installed more than one) ④ the top floor.

Name of the product	Moder	Number
Record system of the effect of isolation	SW-011-SYS	1 set
Seismometers	SW – 011	2 sets

Plan Two

Number of installed seismograph:

①on the ground ② above the vibration isolation system (1 F or B1F), ③the top floor.

Name of the product	Model	Number
Record system of the effect of isolation	SW - 011-1-SYS	1 set
Seismometers	SW – 011	1 set

Instructions to questions about the number of channels.

3 channel for one seismograph ;

Standard configuration of the effect of isolation system (SW - 011 - SYS) contains two seismometers, so the channel number is 6 channel;

Plan Two contains three seismographs, so the channel number is 9 channels.

(Editor：admin)

Returns

Move>>

The building earthquake monito 03-14
Wireless vibration testing of 08-14